Southwire 58701399, Type MP-GC Mining Cable 250 kcmil 3C Copper 5 kV Black CPE
Description
Southwire 58701399 is a 250 kcmil, three-conductor RHINOPOWER™ Type MP-GC mine power feeder cable rated 5 kV. Its three 37-strand Class B compact stranded bare copper phase conductors carry ethylene propylene rubber (EPR) insulation at a 100% insulation level. Two #1/0 grounding conductors and one #8 ground check conductor with yellow insulation run with them. Each phase conductor has conductor and insulation shields and a 5 mil copper tape shield, under a black chlorinated polyethylene (CPE) jacket.
The cable is MSHA Approved.
Southwire 58701399 Technical Specs
Conductors & Insulation
| Conductor Size | 250 kcmil |
|---|---|
| Phase Conductors | 3 |
| Strands per Conductor | 37 |
| Conductor | Class B compact stranded bare copper per ASTM B3 and B496 |
| Insulation | Ethylene propylene rubber (EPR) |
| Insulation Level | 100% |
| Insulation Thickness | 90 mils (2.29 mm) |
| Diameter Over Conductor | 0.520 in (1.32 cm) |
| Diameter Over Insulation | 0.759 in (1.93 cm) |
Grounding & Ground Check
| Grounding Conductors | Two #1/0 Class B compressed stranded bare copper |
|---|---|
| Ground Check Conductor | One #8 Class B compressed stranded bare copper with yellow polypropylene insulation |
Shielding & Jacket
| Conductor Shield | Semi-conducting cross-linked copolymer |
|---|---|
| Insulation Shield | Strippable semi-conducting cross-linked copolymer |
| Copper Tape Shield | Helically wrapped 5 mil copper tape, 25% overlap |
| Outer Jacket | Black chlorinated polyethylene (CPE) |
| Jacket Thickness | 140 mils (3.56 mm) |
Dimensions & Weight
| Approximate Outside Diameter | 2.290 in (5.82 cm) |
|---|---|
| Approximate Weight | 4778 lbs/1000 ft (7110 kg/km) |
Ratings & Standards
| Voltage Rating | 5 kV |
|---|---|
| Type Designation | Type MP-GC |
| Product Line | RHINOPOWER™ |
| Standards | ASTM B3 Soft or Annealed Copper Wire; ASTM B8 Concentric-Lay-Stranded Copper Conductors; ASTM B496 Compact Round Concentric-Lay-Stranded Copper Conductors; ICEA S-75-381 Portable and Power Feeder Cables for Use in Mines |
Southwire 58701399 Applications
- Stationary horizontal high-voltage mine power distribution circuits, permanent or semi-portable.
- Power transmission in deep mines, surface mines, open pits and tunnels.
- Installation in conduit or duct, not exceeding the maximum rated voltage.
- Direct burial in wet or dry locations.
Documents
Images are for reference only. Specifications may change without notice — verify suitability for your application before purchase. The manufacturer's documentation controls.
Need a cut length, bulk pricing, or a spec sheet?
Our team quotes custom lengths and volume orders, usually same day.